Sanyo CHX06052 - Manual (Page 35)

2-17
Remote Control Functions
3. Timer Remote Controller (RCS-TM80BG)
2
2. Names and Operations
1. Start/Stop button
Pushing this button starts, and pushing again stops the
unit.
2. Operation lamp
The lamp is turned on when an air conditioner is in opera-
tion.
This lamp blinks when an error occurs or a protective
device is activated.
3. Mode Select button
Pushing this button to select an operation mode. (AUTO
/HEAT /DRY /COOL /FAN ).
4. Temperature setting buttons
Changing the temperature setting.
5. FAN speed button
Changing the fan speed.
6. Swing/Air direction button *1
Use this button to set the auto swing or air direction to a
specific angle.
7. Unit Select button
When more than one indoor unit is operated by one re-
mote control unit, this button is used to select a unit when
adjusting the air direction.
8. Timer setting buttons
( Weekly Program Function)
9. FILTER reset button
Use this button to reset the filter sign.
When is displayed, press this button after cleaning the
filter.
Operation Section (Refer to the previous page)
10. Ventilation button
Use this button when you installed a fan available in the
market. Pressing this button turns on and off the fan.
When turning off the air conditioner, the fan will be also
turned off.
(While the fan is operating,
will appear in the display.)
*If is displayed on the LCD of the remote control unit
when pressing the ventilation button, no fans are installed.
11. Inspection button
Do not use this button.
12. Sleeping button
( Sleeping Function)
13. Remote control sensor
Normally, the temperature sensor of the indoor unit is
used to detect the temperature. However, it is also pos-
sible to detect the temperature around the remote control
unit.
*1 Do not move the flap (vertical airflow adjustment board)
with your hand.
The flap is automatically directed down when the unit is
stopped.
The flap is directed up during the HEAT standby. The
flap starts swinging after the HEAT standby is can-
celled, although the AUTO flap indication on the remote
control unit is displayed during the HEAT standby.
MiniECO-i.indb 17 2007/06/20 16:28:21