Sanyo CHX06052 - Manual (Page 33)

2-15
Remote Control Functions
2
Check out the following points before requesting service.
If the trouble persists even after performing the checks recommended above, shut down the air conditioner’s operation, set the
local power switch to OFF, and contact your dealer with the model number and trouble symptoms. You must NOT attempt to make
repairs yourself due to the dangers involved. If one or more of the indication lamps is blinking, give this information to the dealer
as well.
y d e m e R e s u a C e l b i s s o P e l b u o r T
C
h
e
c
k
a
g
a
in
.
The air conditioner
does not run even
when the ON/OFF
operation switch has
been set to ON. Is the air conditioner in the shutdown mode or
was the switch operated after a power failure? Press the wireless remote control unit’s
ON/OFF operation button again.
How about the local power switch? If it was off, set it now to on.
Have any of the fuses blown? If a fuse has blown, contact your dealer.
Is the ON timer operation mode established? Clear the timer operation.
If the signal receiver’s NORMAL/ALL OFF
switch set to “ALL OFF”? If it is, set it to the “NORMAL” position and
cancel the operation.
Have the wireless remote control unit’s
batteries run down? If they have, replace them with new ones.
Do the indication lamps show a cooling/heating
mismatch or is the auto cooling/heating
function not available? Change the operation mode.
Auto cooling/heating or heating appears on the display even though the air
conditioner is a cooling-only model. Change the setting of the wireless remote
control unit’s slide switch. (See page 2-10)
e s u a C e l b i s s o P e l b u o r T
C
o
n
ta
c
t y
o
u
r
d
e
a
le
r.
(An indicator lamp is blinking.) • Some kind of trouble has occurred in communication between the signal
receiver and indoor unit. Alternatively, the wrong address has been set
when a wired remote control unit is used.
• Some kind of trouble has occurred in communication between the indoor
unit and outdoor unit.
• The indoor unit’s protection device has been activated. Alternatively, the
auto flap connector of the ceiling panel has been disconnected.
• The outdoor unit’s protection device has been activated.
• Something is wrong with the temperature sensor.
• The outdoor unit’s compressor has been protected.
• A trial run mode is underway. Set the trial run mode to Off.
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
Operation Timer Preparing for
operation
01_XHX1252_EN.fm Page 14 Friday, April 20, 2007 3:28 PM
A, U, D type Initiate operation using the Emergency operation button in the signal receiver.
1. Press the Emergency operation button.
The air conditioner initiates a cooling operation when its operation is started
up at a room temperature of 75°F (24°C) or above.
Conversely, it initiates a heating operation when its operation is started up at a
room temperature below 75°F (24°C).
2. When the SWING button is pressed, the air direction is automatically switched
from upward to downward or vice versa.
Shutdown
Press the Emergency operation button once more.
01_XHX1252_EN.fm Page 13 Friday, April 20, 2007 3:28 PM
2. Wireless Remote Controller
7. Troubleshooting
MiniECO-i.indb 15 2007/06/20 16:28:18