Sanyo CHX06052 - Manual (Page 74)

2-56
Remote Control Functions
4. System Controller (SHA-KC64UG)
NOTE
NOTE
NOTE
(a) Zone registration using the remote controller (RCS-SH80AG)
(Determination of central address)
In this case, after confirming which indoor unit is connected to the
remote controller and that the air conditioner in the OFF state, you
set the central addresses one at a time.
If the system has no remote controller, connect a remote controller
to the system temporarily. Then follow this procedure.
The indoor unit address must already have been set before performing
zone registration. If necessary, refer to the Installation Manual supplied
with the outdoor unit.
(1) Press the
and buttons at the same time for more than 4
seconds.
(2) Do not press button.
(3) Once in this mode, the UNIT No., CODE No., No. of SET DATA and
indications will flash on the display as shown at the right.
In case of group control, “ALL” instead of “UNIT No.” will flash on the
display. Select the main indoor unit address by pressing the
button once.
(4) Set CODE No. to 03 using the
and ( ) buttons.
The CODE No. 03 must be selected to perform zone registration using
the remote controller.
(5) Set the Central address which you want to assign to the indoor unit
address using the and ( ) buttons according to the
zone registration table.
(6) Press the button. The CODE No. and Central address changes
from flashing to ON state. If you make a mistake, then press the
button and reset the central address.
(7) Press the button to finish zone registration.
For example, in this case
Indoor unit address:1-8
Central address : 17 (ZONE 2, GROUP 1)
(b) Zone registration using the system controller (SHA-KC64UG)
In this case, you set all central addresses by the
system controller at once manually.
(1) Press the and buttons at the same time
for more than 4 seconds.
and CODE No. C1 will flash.
(2) After confirming that CODE No. C1 is displayed,
press the button. Once in this mode, a change
takes place as shown at the right.
(3) Select the zone and group No. you want to set
with and (GROUP) buttons.
If already set, press the buttons.
(4) Set the unit No. (indoor unit address) with and
buttons, according to the zone registration table.
R.C. No. .......................... button
Indoor unit No.................. button
(5) Press the button.
GROUP No. turns ON and UNIT No. (indoor unit
address) changes from flashing to ON state.
UNIT No. is registered to selected ZONE No. and
GROUP No.
If you make a mistake, press the button and
reselect the ZONE, GROUP and UNIT No.
(6) Register the other UNIT Nos. in the same way by
following the steps (3) to (5).
(7) Finally, complete the registration by pressing the
button.
flashes for a few minutes, then turns OFF.
Selected
group No. if
no data is
registered.
If no data is
registered,
no number
is displayed.
If data is
registered,
the unit No.
is displayed.
For example, in the case Zone 3, Group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to Zone 3, Group No. 7.
MiniECO-i.indb 56 2007/06/20 16:29:08