Sanyo CHX06052 - Manual (Page 51)

2-33
Remote Control Functions
3. Timer Remote Controller (RCS-TM80BG)
2
All settings except for the central control address
were completed at the time of shipment. The follow-
ing procedures are necessary only when the func-
tions are changed.
The functions cannot be changed in the case of a
wireless remote controller or a system with no remote
controller.
Change the functions using the wired remote con-
troller (RCS-TM80BG).
<Function>
This allows the filter lifetime, operating mode priority
change, central control address, and other settings to
be made for an individual or group-control indoor unit
to which the remote controller used for simple set-
tings is connected.
These settings are for items that are extremely
important for system operation. Serious trouble
may occur if they are set incorrectly. Please use
sufficient caution when changing the settings.
Some item codes which do not appear in the list
are also displayed. These item codes were set at
the time of shipment from the factory to the opti-
mal settings for that model; do not change them.
Do not change any settings data which does not
appear in this list.
<Procedure>
(Perform these steps with the unit stopped.)
Press and hold the (TEST/CHK) and
(VENTILATION) buttons simultaneously for 4 sec-
onds or longer. Check that the (SETTING)
display on the remote controller begins to blink.
If group control is in effect, press the
(UNIT SELECT) button and select the address
(unit No.) of the indoor unit to set. At this time, the
indoor unit fan begins operating.
* If unit No. “ ” is displayed, the same setting
will be made for all indoor units.
Press the temperature setting /
buttons to select the item code to change.
3
2
1
CAUTION
Press the timer time / buttons to select
the desired setting data.
* For item codes and setting data, refer to the fol-
lowing page.
Press the (SET) button. The (SETTING)
display stops blinking and remains lit, and setting is
completed. (If the (SET) button is not pressed,
the settings data will not be changed.)
Repeat steps (2) – (5) and change the settings.
<Restoring normal mode>
Press the (TEST/CHK) button. Check that the
remote controller display disappears.
7
6
5
4
7 2
1 5 4
3
1. Press the remote controller button for 4 seconds or longer.
2. “TEST” appears on the LCD display while the test run is in progress.
3. Then press the button.
The temperature cannot be adjusted when in Test Run mode.
(This mode places a heavy load on the machines. Therefore use it only when performing the test run.)
The test run can be performed using the HEAT, COOL, or FAN operation modes.
Note: The outdoor units will not operate for approximately 3 minutes after the power is turned ON and after operation is
stopped.
If correct operation is not possible, an error code is displayed on the remote controller LCD display.
(Refer to “Table of Self-Diagnostic Functions” and correct the problem.)
4. After the test run is completed, press the button again. Check that “TEST” disappears from the LCD display.
To prevent continuous test runs, this remote controller includes a timer function that cancels the test run after 60 minutes.
The operation is possible even if the cassette-type ceiling panel has not been installed. (“P09” display does not occur.)
15. Simple Setting Function
MiniECO-i.indb 33 2007/06/20 16:28:48