Listing of accessories, Refer to section c, accessories, for more, K29 vertical lift adjuster – Lincoln Electric NA-5S User Manual
Page 38: K58 magnetic separator, K96 horizontal adjuster, K129 submerged arc small wire twinarc, K148 contact nozzle and k149 linc-fill, Long stickout extension, K218 horizontal fillet/lap attachment, K219 flux hopper kit
ACCESSORIES
C-3
C-3
NA-5
LISTING OF ACCESSORIES
K29 VERTICAL LIFT ADJUSTER
When mounted in the NA-5 head mounting
system, the K29 Vertical Lift Adjuster
provides quick hand crank adjustment of the
vertical head position. It also has some
horizontal adjustability as described in Sec.
T3.2.3 of operator’s manual IM305.
Installation instructions are shipped with
each K29 Vertical Lift Adjuster kit, are
contained in the IM305 manual, and can be
ordered as Sec. T2.2.11.
K58 MAGNETIC SEPARATOR
Useful with any submerged arc equipment.
The unit removes foreign magnetic particles
from reused submerged arc welding flux.
Operating instructions are included with the
kit.
K96 HORIZONTAL ADJUSTER
When mounted in the NA-5 head mounting
system, the K96 Horizontal Adjuster
provides quick hand crank adjustment of the
horizontal head position. Installation
instructions are shipped with each K96
Horizontal Adjuster kit, are contained in the
IM305 manual, and can be ordered as Sec.
T2.2.12.
K129 SUBMERGED ARC SMALL
WIRE TWINARC
®
The Twinarc system provides for the feeding
of two small solid wires through a single wire
feeder. The Twinarc assembly includes a
wire reel, reel brake, shaft and mounting
bracket, drive roll, idle roll assembly, dual
wire guides, and nozzle and contact tip or
contact tip holder. Instructions are shipped
with each kit, are contained in the IM305
manual, and can be ordered as Sec. T2.5.3
K129.
K148 CONTACT NOZZLE AND
K149 LINC-FILL
TM
LONG
STICKOUT EXTENSION
This Innershield and submerged arc nozzle
is designed for 0.062 through 3/16 in.
(1.57 through 4.76 mm) wire at high
currents. When long stickout [2 to 5 (50.80
to 127.00 mm)] is required, the K149
Linc-Fill Long Stickout Extension is
recommended along with the K237 Linc-Fill
Starting Relay. Instructions are contained in
the IM305 manual and can also be ordered
as Sec. T2.2.7.
K218 HORIZONTAL
FILLET/LAP ATTACHMENT
This special contact assembly automatically
guides the electrode when making
submerged arc horizontal fillet and lap welds
to ensure accurate bead placement without
expensive fixtures and clamps. Installation,
operating, and maintenance instructions are
shipped with each kit, are contained in the
IM305 manual, and can also be ordered as
Sec. T2.5.4.
K219 FLUX HOPPER KIT
This flux hopper, which has an electric flux
valve, can be mounted on NA-5N and
NA-5NF heads for submerged arc welding.
Installation instructions are included with
each kit. The operator and maintenance
instructions are contained in the IM305
manual and can also be ordered as
Sec. T2.5.9.
K223 SOLENOID KIT
The solenoid kit includes a valve to control
water flow when using the cooling
attachment on the K148 or K239 contact
nozzle assembly. It opens when the start
button is pressed and can be wired to close
either when the stop button is pressed or
when the arc goes out. Installation
instructions are shipped with each kit.