Lexicon RT-10 - Manual (Page 113)

Playback Controls
Lexicon
4-20
4. When the desired repeat playback mode is selected, press the
Play button or the remote control ENTER button to activate the
selected repeat playback mode.
• Select Repeat Off to deactivate repeat playback. (This
option is only available if program playback was activated
when the REPEAT button was pressed.)
To deactivate repeat playback:
• Press the remote control CLEAR button to activate playback
from the current playback time. The Repeat Off bar shown
above (right) will open at the top of the on-screen display to
indicate that repeat playback has been deactivated.
• Press the Stop button to activate stop or resume mode. In
some cases, the Stop button must be pressed twice in succession
to activate stop mode. When stop mode is activated, playback
cannot be reactivated at the current playback time.
2. When playback is activated, press the REPEAT button to open
one of the Repeat bars shown above will open at the top of the
on-screen display.
• The Repeat bar indicates the selected repeat playback
mode.
• If the Repeat bar does not open at the top of the on-screen
display, repeat playback might not be available for the
loaded disc. The table on page 4-12 indicates the repeat
playback modes available for each disc format.
3. When the Repeat bar opens, press the REPEAT button again to
cycle through all repeat playback modes available for the
loaded disc.
• If program playback was activated when the REPEAT
button was pressed, repeat program playback is available.
Other repeat playback modes are not available.
Note:
The Repeat bar automatically closes a few seconds
after the last command is received. When this occurs,
the selected repeat playback mode is automatically
activated.
Repeat Playback (continued from page 4-19)
Repeat
Folder
Repeat
Chapter Repeat
Track
Repeat
Group
Repeat
Title
Repeat
Off Repeat
All
Repeat
Disc
Program
Repeat