Lexicon RT-10 - Manual (Page 92)

Setup Menus
Lexicon
3-52
DISP_MODE DISP_ON, DISP_OFF
Determines the front panel display mode for SACD, CD, and MP3
playback. This parameter setting has no effect when other disc
formats are loaded.
Select DISP_ON to deactivate the front panel display and rear panel
video output connectors during SACD, CD, and MP3 playback.
When SACD, CD, or MP3 playback is activated, press the front
panel Display Off button or the remote control DIMMER button to
activate the front panel display for 3 seconds. When stop mode is
activated, the front panel display remains activated until playback
resumes. The video output connectors remain deactivated until the
DISP_MODE parameter is set to DISP_OFF.
Select DISP_OFF to activate the front panel display and rear panel
video output connectors during SACD, CD, and MP3 playback. The
front panel display and rear panel video output connectors will
function as normal.
Note:
The DISP_MODE parameter might not function as
described with some SACDs, CDs, or MP3s. If this
occurs, set the DISP_MODE parameter to DISP_OFF so
the front panel display and rear panel video output
connectors will function as normal.
AUTO_P ON_30MIN, OFF
Enables and disables automatic standby mode activation. When
ON_30MIN is selected, the RT-10 automatically activates standby
mode after 30 minutes of non-use. When OFF is selected, the RT-10
does not automatically activate standby mode after 30 minutes of
non-use.
Advanced Setup Menu (continued from page 3-51)
To open the Advanced Setup menu:
1. Press the Stop button to activate stop mode. In some cases, the
Stop button must be pressed twice in succession to activate
stop mode.
2. If the Setup menu is closed, proceed to step 3. If the Setup
menu is open, press the remote control Setup button to close
the Setup menu. The Advanced Setup menu is not available
when the Setup menu is open.
3. When stop mode is activated and the Setup menu is closed,
press and hold the SETUP button for about 2 seconds. The
front panel Display Off button LED will begin blinking,
indicating that the Advanced Setup menu is open on the front
panel display.
• When the Advanced Setup menu is open, the DISP_MODE
parameter appears on the front panel display as shown on
the previous page (first column, first row).
To navigate the Advanced Setup menu:
Button Command
ENTER Selects the highlighted parameter or setting.
and Scroll upward and downward through
parameters. When a parameter is selected,
pressing the
and arrows scrolls upward
and downward through parameter settings.
SETUP Closes the Advanced Setup menu.