Lexicon RT-10 - Manual (Page 60)

Setup Menus
Lexicon
3-20
Note:
Speaker distance settings have no effect when:
• An SACD is loaded.
• The RT-10 is using the 2-channel analog audio
output connectors.
• The RT-10 is using the digital audio output
connector.
To set speaker distances:
1. When the Speaker Size screen opens, press the remote control
arrow to open the Speaker Distance screen.
2. When the Speaker Distance screen opens, press the and
arrows to highlight the desired parameter.
2. When the desired parameter is highlighted, press the and
arrows to cycle through available settings.
3. When the desired setting is selected, press the arrow to
highlight the Distance option at the top of the on-screen
display. Then, pressing the
arrow to open the Speaker Size
screen or the remote control ENTER button to return to the
Setup menu.
Note the following:
• To determine the appropriate setting for each speaker,
measure the distance between the listening position and the
front baffle of the speaker. Then, set the associated speaker
distance parameter to the closest available value.
Audio2 (continued from page 3-19)
Setting Speaker Sizes
(continued)
Note the following:
• The SW parameter determines the presence or absence of a
subwoofer. Select On if a subwoofer is present. The RT-10 will
pass subwoofer signals and LFE signals for which the
corresponding Speaker Size parameter is set to Small to the
Sub analog audio output connector. Select Off if no subwoofer
is present. The RT-10 will not redirect LFE signals to other
analog audio output connectors.
• When speaker size parameters are set to Off, the corresponding
speaker distance parameters cannot be adjusted.
• The L/R parameter size setting cannot be adjusted. This
parameter has a fixed Large setting to provide full-range audio
output through the front left and right channels.
• Because surround speakers must be the same size, the LS and
RS parameters cannot be set to different sizes. When the
setting of one parameter is adjusted, the setting of the other
parameter is automatically adjusted at the same time.
Setting Speaker Distances
The Speaker Distance screen shown at the top of the previous page
can be used to set speaker distances for the front, center, surround,
and subwoofer speakers.