Setup menus, Dts out, Linear pcm out – Lexicon RT-10 User Manual

Page 53

Advertising

Setup Menus

RT-10

3-13

DTS Out

DTS, DTS

PCM

Controls DTS audio output format when a DTS source is present
and the RT-10 is using the digital audio output connector.

Select DTS if the associated component is compatible with DTS
sources. The RT-10 will pass DTS signals directly to the associated
component. Select DTS

PCM if the associated component is not

compatible with DTS sources. The RT-10 will convert DTS signals to
PCM before passing them to the associated component.

Associated components that are NOT compatible with DTS
sources will output DTS noise when all of the following
conditions are met:

•

A DTS source is present.

•

The Digital Jack prompt is set to Dolby Digital/DTS or Dolby
D/DTS/MPEG OR the DTS Out parameter is set to DTS.

Audio DRC --- Off

Dolby Digital Out --- Dolby Digital

DTS Out --- DTS PCM

Linear PCM Out --- Down Sample On

MPEG Out --- MPEG PCM

Digital Out --- On

SACD Playback --- 2ch Area

Audio1

Language General

Video1

Move

Exit

SETUP

DTS
DTS PCM

DTS Out

The DTS Out parameter is associated with the Setup Navigator
Digital Jack prompt (3-7). The DTS Out parameter and Digital Jack
prompt settings have no effect when the RT-10 is not using the
digital audio output connector.

Linear PCM Out

Down Sample On, Down Sample Off

Controls PCM digital audio output format when a 96kHz PCM
digital audio source is present and the RT-10 is using the digital
audio output connector.

Select Down Sample On if the associated component is not
compatible with 96kHz PCM sources. The RT-10 will downsample
96kHz PCM signals to 48kHz before passing them to the associated
component. Select Down Sample Off if the associated component
is compatible with 96kHz PCM sources. The RT-10 will not
downsample 96kHz PCM signals before passing them to the
associated component.

. . . Audio1 continues on page 3-14