Lexicon RT-10 - Manual (Page 68)

Setup Menus
Lexicon
3-28
Video1 (continued from page 3-27)
TV Screen --- 16:9 (Wide)
Component Video --- Progressive
Video Out --- Video
S-Video Out --- S2
Frame Search --- Off
Screen Saver --- Off
Audio1 Language General Video1 A2 V2
Move Exit SETUP
S1
S2 S-Video Out
TV Screen --- 16:9 (Wide)
Component Video --- Progressive
Video Out --- Video
S-Video Out --- S2
Frame Search --- Off
Screen Saver --- Off
Audio1 Language General Video1 A2 V2
Move Exit SETUP
On
Off Frame Search
S-Video Out S1, S2
Determines the trigger control signal present when the RT-10 is
using the S-video output connector, providing control of
anamorphic display switching. Select the S1 setting to enable
automatic switching between 16:9 and 4:3 video output formats.
Select the S2 setting to enable automatic switching between 16:9,
4:3 standard, and 4:3 letter box video output formats.
The S-Video Out parameter controls anamorphic display
switching when all of the following conditions are met:
• The RT-10 has an S-video output connection to the associated
display device.
• The associated display device is compatible with the selected
anamorphic trigger control signal.
• The loaded disc supports the selected anamorphic trigger
control signal.
It is recommended to toggle between the S1 and S2 settings if the
picture appears stretched or otherwise distorted on the display
device screen.
Frame Search On, Off
Enables and disables the time and time & frame search modes
(4-28). When On is selected, these search modes are enabled for
compatible disc formats. When Off is selected, these search modes
are disabled for all disc formats.
Screen Saver On, Off
Activates and deactivates the Lexicon screen saver. When On is
selected, the Lexicon screen saver appears on the on-screen display
when a still frame image has appeared on the display device screen
for more than 5 minutes. When Off is selected, the Lexicon screen
saver does not appear on the on-screen display.
Note:
Still frame images displayed on CRT display devices
for long periods of time can "burn in" or create "ghost
images" on the screen. When the RT-10 is connected
to a CRT display device, it is recommended to set
the Screen Saver parameter to On to prevent the
appearance of "ghost images" on the screen.
TV Screen --- 16:9 (Wide)
Component Video --- Progressive
Video Out --- Video
S-Video Out --- S2
Frame Search --- Off
Screen Saver --- Off
Audio1 Language General Video1 A2 V2
Move Exit SETUP
On
Off Screen Saver