Lexicon RT-10 - Manual (Page 119)

Playback Controls
Lexicon
4-26
• The currently playing title will be added to the end of the
program title list when a program title list has been created for
the loaded disc and a program chapter list has not been
created for the currently playing title. Likewise, the currently
playing group will be added to the end of the program group
list when a program group list has been created for the loaded
disc and a program track list has not been created for the
currently playing group.
• When no program lists have been created for the loaded disc:
– If the last program list modified was a program title or
group list, a program title or group list will be created,
beginning with the currently playing title or group.
– If the last program list modified was a program chapter or
track list, a program chapter or track list will be created,
beginning with the currently playing chapter or track.
To delete a non-stored program list:
Note:
This procedure cannot be used to delete DVD-V and
DVD-RW/R program lists that have been previously
stored. Refer to the next page for instructions to
delete DVD-V and DVD-RW/R program lists that have
been previously stored.
1. Load a disc for which a program list has been created.
2. Press the Stop button to activate stop mode. In some cases, the
Stop button must be pressed twice in succession to activate
stop mode.
3. When stop mode is activated, press the remote control CLEAR
button to delete the oldest non-stored program list.
Program Mode (continued from page 4-25)
7. When the desired values have been entered, press the Play or
ENTER button to close the Program tab and activate program
playback.
• Press the PROGRAM button to close the Program tab
without activating program playback.
• Refer to the Repeat Playback section that begins on page
4-20 to activate repeat program playback.
To add the currently playing title, chapter, group, or track to an
existing program list:
1. Activate playback of a disc for which a program list has been
created.
2. When playback of the desired title, chapter, group, or track is
activated, press the remote control PROGRAM button for
about 1 second.
• If this is a DVD program list, refer to the notes that begin
below.
• If this is an SACD, CD, or SVCD program list, the currently
playing track will be added to the end of the program track
list. If no program track list has been created for the loaded
disc, a new program track list will be created beginning
with the currently playing track.
Note the following:
• The currently playing chapter will be added to the end of the
program chapter list when a program chapter list has been
created for the currently playing title. Likewise, the currently
playing track will be added to the end of the program track list
when a program track list has been created for the currently
playing group.