Lexicon RT-10 - Manual (Page 24)

1
Basic Operation
Lexicon
2-2
2. Standby LED
Lights to indicate that standby mode is activated. Standby
mode can be activated and deactivated with the remote
control POWER button or with an associated component
connected to the RT-10 trigger input connector. Standby mode
is automatically activated after 30 minutes of non-use when
the AUTO_P parameter (3-52) is set to ON_30MIN.
When the RT-10 is not configured for trigger control, the
remote control POWER button can be used to activate and
deactivate standby mode. When the RT-10 is configured for
FRONT PANEL OVERVIEW
1. On/Off Button
Connects power from the AC input connector to the RT-10.
When the RT-10 is powered on, pressing the On/Off button
powers the RT-10 off and automatically deactivates standby
mode. When the RT-10 is powered off, pressing the On/Off
button powers the RT-10 on. When the RT-10 is powered on,
standby mode is deactivated, even if standby mode was
activated when the RT-10 was powered off. The On/Off button
cannot be used to activate standby mode.
On/Off
Standby
RT-10 Disc Player
Display
Off
Open/Close
The numbers in the RT-10 front panel illustration shown above correspond to the numbered items that begin below.
4 5 9 10
2 6 7 8 3