Lexicon RT-10 - Manual (Page 139)

Troubleshooting & Maintenance
Lexicon
5-10
Speaker settings seem ineffective.
1. Certain speaker settings have no effect on some disc formats.
For instance, speaker size settings (3-19) have no effect on
DVD-As and speaker distance settings (3-20) have no effect on
SACDs.
2. Make sure the RT-10 and all associated components are
configured with the correct speaker settings. RT-10 speaker
settings do not need to be configured when the RT-10 is
connected to an associated component such as the MC-12
Digital Controller, which allows speaker settings to be configured
for analog audio sources. The associated component must not
be using analog audio connections in bypass.
Variable output level settings seem ineffective.
1. Make sure the CD Digital Direct parameter (3-24) is set to Off.
When this parameter is set to On, variable output level settings
are ineffective.
2. Make sure the RT-10 and all associated components are
configured with the correct output level settings. RT-10 variable
output levels do not need to be configured when the RT-10 is
connected to an associated component such as the MC-12 or
MC-8 Digital Controller, which allows output levels to be
calibrated for analog audio sources.
Test Tones (3-21) will not activate.
1. Press the Stop button to activate stop mode. Test Tones cannot
be activated when playback, resume, or pause mode is
activated.
Setup Menu Issues (continued from page 5-9)
Setup menu parameter settings are cancelled.
1. Parameter settings might not have been stored if the RT-10 was
powered off or standby mode was activated before the Setup
menu was closed. If this occurs, all parameters are reset to their
previously stored setting.
2. All Setup menu parameters are reset to their factory-default
setting when a power failure (such as a power cord disconnect)
occurs or factory-default settings are restored.
Note:
Whenever possible, power the RT-10 off or activate
standby mode instead of disconnecting the power
cord.
Setup menu parameter settings seem ineffective.
1. Certain Setup menu parameter settings have no effect on some
disc formats (3-11).
2. If playback is activated, press the Stop button to activate stop
mode. Some Setup menu parameters can be adjusted when
playback is activated, even though the setting does not take
effect until stop mode is activated.