Lexicon RT-10 - Manual (Page 93)

Setup Menus
RT-10
3-53
REMOT_CODE DVD_1, DVD_2
Assigns a remote control command mode to the RT-10. When
DVD_1 is selected, the RT-10 can be operated with an RT-10
remote control to which the DVD_1 command mode is also
assigned. When DVD_2 is selected, the RT-10 can be operated with
an RT-10 remote control to which the DVD_2 command mode is
also assigned.
Assigning Remote Control Command Modes
The RT-10 remote control can be used to operate two RT-10s
installed in the same system when the DVD_1 command mode is
assigned to one RT-10 and the DVD_2 command mode is assigned
to the other RT-10. These command modes can also be assigned to
the remote control, allowing the remote control to operate an
RT-10 to which the same command mode is assigned. The remote
control cannot be used to operate an RT-10 to which a different
command mode is assigned, except to configure Advanced Setup
menu parameter settings.
Note:
The DVD_1 command mode is intended for use when
two RT-10s are installed in the same system.
Otherwise, avoid assigning the DVD_1 command
mode to the RT-10 and the RT-10 remote control.
When one RT-10 is installed in the system, follow the instructions
in the next column to assign the DVD_2 command mode to the
remote control and the RT-10. The DVD_2 command mode is
assigned to the RT-10 when factory-default settings are restored.
The command mode assigned to the remote control is not affected
when factory-default settings are restored.
When two RT-10s are installed in the same system, follow the
instructions below to assign the DVD_1 command mode to one
RT-10 and the DVD_2 command mode to the other RT-10. Follow
the instructions below to toggle the command mode assigned to
the remote control, allowing the remote control to provide
independent operation of both RT-10s.
To assign the DVD_2 command mode to the remote control:
Press and hold the remote control STOP and number 2 buttons
for about 5 seconds.
To assign the DVD_1 command mode to the remote control:
Press and hold the remote control STOP and number 1 buttons
for about 5 seconds.
To confirm the command mode assigned to the remote control:
Press and hold the remote control STOP and PAUSE buttons for
about 2 seconds. The command mode assigned to the remote
control will appear on the front panel display.
To assign a command mode to the RT-10:
Follow the navigation instructions on the previous page to set the
REMOT_CODE parameter to the desired command mode.