Lexicon RT-10 - Manual (Page 117)

Playback Controls
Lexicon
4-24
Note the following:
• Program tabs automatically close a few seconds after the
last command is received. If this occurs, all program list
modifications that have not been previously stored will be
deleted.
• If the Program tab automatically closes when the Program
Memory parameter is set to Off, all program list
modifications that have not been previously stored will be
deleted. It is recommended to set the Program Memory
parameter to On to ensure that all program list
modifications will be stored.
3. When the desired Program tab is selected, press the and
arrows to select the Program Memory parameter at the bottom
of the Program tab.
Program Memory On, Off
Determines DVD-V and DVD-RW/R program list storage. This
parameter is not available for other disc formats.
When On is selected, program lists for the loaded disc are
stored until factory-default settings are restored. When Off is
selected, program lists for the loaded disc are automatically
deleted when the disc drawer is opened, standby mode is
activated, the RT-10 is powered off, or factory-default settings
are restored.
The Program Memory parameter setting applies to all program
lists that have been created for the loaded disc. In other words,
the Program Memory parameter cannot be set to On for a
program title list and to Off for a program chapter list.
Program Mode (continued from page 4-23)
To create a program list:
Note:
These instructions can be used to create MP3
program lists with the MP3 Program tab. Refer to
page 4-27 for instructions to create MP3 program
lists with the MP3 Navigator.
1. When a disc is loaded, press the remote control PROGRAM
button to open one of the Program tabs shown at the top of
the next page. The Program tab that was last modified will
open on the on-screen display.
• If a Video CD or SVCD is loaded, stop mode must be
activated before the PROGRAM button is pressed.
• If this is a DVD program list, proceed to step 2.
• If this is not a DVD program list, proceed to step 6.
2. When a Program tab opens, press the remote control and
arrows to select the desired Program tab.
• If this is a DVD-V or DVD-RW/R program list, proceed to
step 3.
• If this is a DVD-A program group list, proceed to step 5.
• If this is a DVD-A program track list, proceed to step 6.