Panasonic WJ-NT204 - Manual (Page 108)

109
t VCR CONTROL PANEL
Opens the VCR control panel on the bottom center of
the window.
y VCR/CAMERA SELECT
Alters the FS616’s output between the VCR playback
and live camera image.
u MULTISCREEN SELECT
Clicking this button repeatedly will switch the screen
segments as follows:
4
→
7
→
9
→
10
→
13
→
16
→
4 screen segments
i SEQUENCE
The sequential images preset to the WJ-FS616 are dis-
played.
o PRESET SELECT (Bottom window panel)
To move the combination camera (option) connected to
the WJ-FS616 to any of 64 preset positions. Select a
preset position number, and then click the
[SET] button
to move the camera to the position.
!0 ALARM ALL RESET
To reset all alarms activated in the Video Multiplexer,
and return it to normal condition.
!1 PAN/TILT
Click on any of the pan/tilt buttons: Up, Down, Right or
Left to move the pan/tilt head of the Combination cam-
era to the desired direction. Click the button repeatedly
as necessary not holding down it.
!2 ZOOM
Click the button to zoom in or out. Instead holding
down the button, click on it repeatedly as necessary.
TELE: Zooms in the image.
WIDE: Zooms out the image.
!3 FOCUS
Click NEAR or FAR to adjust the focus of the image
manually. Instead holding down the button, click on it
repeatedly as necessary.
NEAR: Manual focusing
FAR: Manual focusing
AUTO: The built-in focus mechanism performs in the
Combination camera.
!4 IRIS
The connected combination camera (option) can be
controlled to close or open the iris by clicking the
[CLOSE] or [OPEN] button under IRIS.
Clicking the [OPEN] or [CLOSE] button will open or
close the camera iris for a specified time, after which
the operation is released automatically.
Clicking the
[RESET] button on the screen will reset
the iris of the displayed camera to the factory default
setting. Iris control cannot be retained by keeping the
[OPEN] or [CLOSE] button depressed. You need to
click the [OPEN] or [CLOSE] button again.
!5 AUTO PAN
The auto pan status of the connected combination
camera (option) can be changed by clicking the
[ON]
or [OFF] button under AUTOPAN.
Note: Note: When LOCAL is selected in the camera
setup menu, auto pan is released automatically
within 1 minute. When REMOTE is selected, auto
pan will not be released automatically.
!6 Status Window
Displays information when an alarm is activated on the
WJ-FS616.
!7 Image Display
Displays the image output supplied from the MULTI-
SCREEN OUT connector on the video multiplexer to the
WJ-NT204.