Panasonic WJ-NT204 - Manual (Page 71)

72
■ Operation Mode
Image transmission is carried out as follows between the transmitter WJ-NT204 and the PC on the Control sites.
● Random Input Selection Mode
The WJ-NT204 transmits continuous image of a single camera to the multiple PC when connected. The image will change if a
PC sends a command to switch the camera channel from one to another. This may cause a sudden change of monitoring
image on the sites other than that it operated.
Up to four (4) PC sites are accessible to one transmitter when the mode is set to H.323/H.261, or six (6) are accessible when
set to JPEG.
1
1
1
1
PC
PC
PC
PC
WJ-NT204
CAMERA 1
CAMERA 2
CAMERA 3
CAMERA 4
LINK/ 10BASE-T 100 BASE-TX CONNECT ACT
LOW HIGH
RING.VOL
Network Interface Unit WJ-NT
POWER
ON
OFF
■ Push Mode
The unit continues to transmit the latest image data per a preset interval in reply to the PC’s command.
PC (browser)
Network
Newest image is continuously
sent from the WJ-NT204.
Camera (max. 4)
Coaxial cable
(video + control)
WJ-NT204