Panasonic WJ-NT204 - Manual (Page 91)

92
■ RECEIVING SETUP
On the ADMINISTRATOR SETUP PAGE , click the RECEIVING button to display the RECEIVING SETUP window.
q
w
e
r
t
q RECEIVING MODE READY STATE
The default setting is AUTO.
AUTO: Calls are received automatically.
MANUAL: Calls can be received by pressing the DIAL
button.
w RINGER
This setting takes effect only when H.261 is applied.
The default setting is ON.
ON: Enables alert tone when a call is received.
OFF: Disables alert tone when a call is received.
e CALLING IP ADDRESS CHECK
The default setting is OFF.
ON: If call reject/allow addresses are set, the IP
addresses of incoming calls are checked.
The check sequence advances as follows.
1 The caller address is checked whether it is in the
range of REJECT IP address.
If it is Yes, the caller will be rejected.
If it is No, check goes to the next step 2 below.
2 The caller address is checked whether it is in the
range of ACCEPT IP address.
If it is Yes, the caller will be connected.
If it is No, check goes to the next step 3 below.
3 The caller address is checked whether it is
included in the Quick Dialing directory.
If it is Yes, the caller will be connected.
If it is No, the caller will be rejected.
OFF: Even if call reject/allow addresses are set, the IP
addresses of incoming calls are not checked.
Therefore, the call reject/allow function remains
inactive.
r REJECT IP/SUBNET MASK REGI.
Set IP addresses and subnet masks to be rejected. Up
to 3 can be set. All IP addresses other than the set
ones will be allowed.
t ACCEPT IP/SUBNET MASK REGI.
Set IP addresses and subnet masks to be allowed. Up
to 3 can be set. All IP addresses other than the set
ones will be rejected.