Panasonic WJ-NT204 - Manual (Page 69)

70
MAIN PAGE AND CONTROLS
There are two image transmission/reception methods to monitor remote places on the WWW browser: the H.261 and JPEG.
One mode must be selected at the Remote site unit (transmitter), and the selected mode must be used for all transmitters in
the system.
You need to install a plug-in software into your PC before monitoring images based on the H.323/H.261 standard with use of a
browser software. When using JPEG, you need not install it.
■ Main Page and Control Windows
On the Location bar of the PC, type http://192.168.0.10 (or IP address set for WJ-NT204) to display the MAIN PAGE default
window.
The MAIN PAGE window appears following the default page registered in the “MODE SETUP” window.
Note: Image quality and motion on the browser may be lowered slightly than that of 1 to 1 connection when multiple sites
are connected.
The mode 1 to 4 windows may differ slightly depending on the operation mode.
For the Main Page setup see MODE SETUP on page 81.
■ Installing an H.323 Plug-in to PC
You need to install a plug-in software into your PC before monitoring images based on the H.323/H.261 standard with use of a
browser software. Follow the steps 1 and 2 below when using Internet Explorer, or steps 1, 2 and 3 when using Netscape.
1. Put in the floppy disk.
2. Execute the setup.exe.
3. Execute the Setup-Netscape.exe when using Netscape.
Notes:
• A message “Unable to init audio” appears right after starting the browser if no sound board is installed in the PC.
• Only reception is available for video and audio.