Panasonic WJ-NT204 - Manual (Page 78)

79
SETUP PROCEDURES
■ How to Read ADMINISTRATOR SETUP PAGE
On the Location bar, type http://192.168.0.10/hwsetup.html to display the ADMINISTRATOR SETUP PAGE . To open the
ADMINISTRATOR SETUP PAGE , you need to enter your user ID and password. The default ID and password are [admin]
and [any character], respectively.
Notes:
• Settings for a transmitter can be operated through a WWW browser window when a PC works as a Receiver, and through
the 700 REMOTE SETUP EDIT window when a WJ-NT204 works as a Receiver. The latest change will take effect when
more than one Control site operate the settings at a time as far as they have the same access priority.
• Settings for a WJ-NT204 receiver are not operable through a WWW browser window.
• Click the Reload button on the browser when changing the window from H.323/H261 operation to the ADMINISTRATOR
SETUP PAGE. Reloading will ensure the new window display, although this change results in a disconnection, thus the
new display takes time.
q
w
e
r
t
y
u
i
o
!0
!1
!2
!4
[SET][SUBMIT] button
Clicking this button stores the settings made on the
ADMINISTRATOR SETUP PAGE in the WJ-NT204.
The setting range of this button is indicated by the
ruled line that separates one item from another. The
area showing the data within the range returns to the
original display when the button is clicked.
The system is not restarted when this button is clicked.
[SET & REBOOT] button
Clicking this button stores the settings made on this
page in the WJ-NT204.
q MODE SETUP
To set the default page when a file name is specified.
Also set operation mode, image quality, and camera
control selection on this page.
w NETWORK
To set the IP address, netmask and default gateway.
e VIDEO SEQ/ALARM
Click this button to open the VIDEO SEQ SCAN/,
ALARM SETUP where you can specify the video
sequence ON/OFF, alarm reception ON/OFF and so
forth.
r SERIAL PORT
Click this button to open the SERIAL PORT SETUP
where you can specify parameters for serial communi-
cations in the RS-232C or RS-485 protocol.
t USER
Click this button to open the USER SETUP window
where you can set up USER AUTHORIZATION, USER
REGISTRATION and USER DELETION.
!3