Panasonic WJ-NT204 - Manual (Page 95)

96
q ONE-TOUCH DIALING REGISTRATION
The five ONE TOUCH DIAL buttons on the Remote
Controller can be assigned the start point of sequential
dial (SEQ. DIAL) or one-touch dial numbers. Pressing
the one-touch button will call the start point of SEQ.
DIAL if it is registered as “000”. Pressing other one-
touch dial buttons than “000” will call the assigned IP
address to the button.
w RE-CONNECTION
Re-connection is started by the site that is set to ON for
this setting when a call is interrupted during communi-
cation. This setting is applicable only to the system
comprising two WJ-NT204 units, one for TRANSMITTER
and the other for RECEIVER, and when the call has
been made with the Remote Controller WV-CU20. This
does not perform in the multi-site connection.
e HOST PORT
The DIP switch #9 on the front of the WJ-NT204 unit
specifies the usable serial port from RS-232C (front) or
RS-485 (rear) (PS.Data). The settings must be the same
among the devices connected in the chain, except the
unit #.
r ON SCREEN DISPLAY
Elements displayed on the monitor connected to the
WJ-NT204 transmitter are selected to ON or OFF.
t LOCK/PASSWORD
MENU LOCK enables (ON) or disables (OFF) the pass-
word protection when opening the menu windows.
NUM LOCK enables (ON) or disables (OFF) the numer-
ic buttons to operate on the Remote Controller.
A PASSWORD comprises 4-digit of numeric characters
(0-9), asterisk (*) and sharp (#).