Panasonic WJ-NT204 - Manual (Page 31)

31
■ On the Control Site (Receiver)
Connections on the Control site is outlined below in the figure.
1. MONITOR Connection
Connect the MON/SPOT terminal to the monitor.
Connect the AUDIO OUT terminal to the monitor.
2. PARALLEL IN-OUT Connections
Connect the PARALLEL OUT terminals with Auxiliary devices (e.g., an electric lamp and a relay). These devices will be
activated when optional switches connected to the PARALLEL IN terminals are closed on the Remote site.
Connect the PARALLEL IN terminals with optional switches to control the Auxiliary devices on the Remote site.
3. Connect the REMOTE terminal to the WV-CU20 Remote Controller with the supplied cable (6-conductor, straight wiring,
included in the WV-CU20).
4. Connect the RS-485 DATA PORT to a WV-CU360 System Controller with RS-485 cable. The WV-CU360 will control
PS • Data equipment on the Remote site through the network, and will also control the Control site equipment.
5. Connect the 10/100BASE-T terminal to an Ethernet with a 10BASE-T or 100BASE-TX cable.
ON
OFF
POWER
RS–232C RS–485
AUX
1
I N
REMOTE SETUP HOST PORT DATA PORT DATA PORT 10BASE-T/100BASE-TX
OUT
OUT
I N
SENSOR IN/TRIGGER OUT PARALLEL PORT
MON/SPOT AUDIO
ESC
MENU
AF NEAR FAR TELE WIDE
Remote Controller WV-CU20
1 2 3
4 5 6
7 8
0
9
1 2 3 4 5
#
STEP 1 DIAL
PRESET SET
QUICK
STEP 2 STEP 3 CALL
REDIAL
DELETE
ENTER
AUDIO MUTE
ALM ACK VIDEO SWITCH ONE TOUCH DIAL
AUTO/MANU SITE
10/100BASE-T Cable
Monitor
Remote Controller
WV-CU20
System Controller
ex.) WV-CU360
To Network
BZ
Lamp Buzzer Relay
Auxiliary Devices
1 2 3 4 5 6 7 8
Auxiliary Control Switc
System Controller
Network
Interface Unit
(Receiver)
Receiver does not use.
Control Site Connection
Microphone
Amplifier