Planet Technology WGSD-8000 - Manual (Page 177)

User’s Manual of WGSD-1022/WGSD-8000
- 177 –
ƒ forward — Forwards frames with unlearned source addresses, but does not learn the address.
ƒ discard — Discards frames with unlearned source addresses. This is the default if no option is indicated.
ƒ discard-shutdown — Discards frames with unlearned source addresses. The port is also shut down.
ƒ trap Seconds — Sends SNMP traps and defines the minimal amount of time in seconds between two consecutive traps.
(Range: 1 - 1,000,000)
Default Configuration
Disabled - No port security
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, frame forwarding is enabled without learning, and with traps sent every 100 seconds on port e18.
console (config)# interface ethernet e18
console (config-if)# port security forward trap 100
5.4.12 port security routed secure-address
The port security routed secure-address interface configuration command adds MAC-layer secure addresses to a routed
port. Use the no form of this command to delete the MAC addresses.
Syntax
port security routed secure-address mac-address
no port security routed secure-address mac-address
ƒ mac-address — Specify a MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface configuration (Ethernet, port-channel). Cannot be configured for a range of interfaces (range context).
User Guidelines
The command enables adding secure MAC addresses to a routed ports in port security mode. The command is available when
the port is a routed port and in port security mode. The address is deleted if the port exits the security mode or is not a routed
port.