Planet Technology WGSD-8000 - Manual (Page 90)

User’s Manual of WGSD-1022/WGSD-8000
- 90 –
Figure 4-35 CoS Settings screen
The Page contains the following fields:
• CoS Mode
This indicates if QoS is enabled on the interface. The possible values are:
• Disable, disables QoS on the interface.
• Basic, enables QoS on the interface.
• Advanced, enables the Advanced Mode QoS on the interface.
• Class of Service Specifies the CoS priority tag values, where zero is the lowest and 7 is the highest
• Queue Defines the traffic forwarding queue to which the CoS priority is mapped.
Four traffic priority queues are supported
The Restore Defaults button restores the device factory defaults for mapping CoS values to a forwarding queue.
„ CoS Default:
The Table contains the following fields:
• Interface Interface to which the CoS configuration applies
• Default CoS Determines the default CoS value for incoming packets for which a VLAN tag is not
defined. The possible field values are 0-7.
The default CoS is 0
• Restore Defaults Restores the device factory defaults for mapping CoS values to a forwarding
queue.
• LAG LAG to which the CoS configuration applies.
4.8.2 Queue Setting
The Queue Setting screen (see figure 4-36) contains fields for defining the QoS queue forwarding types.