6 spanning-tree priority, 7 spanning-tree disable – Planet Technology WGSD-8000 User Manual

Page 298

Advertising
background image

User’s Manual of WGSD-1022/WGSD-8000

- 298 –

Console(config)# spanning-tree max-age 10

5.21.6 spanning-tree priority

The spanning-tree priority global configuration command configures the spanning-tree priority. The priority value is used to

determine which bridge is elected as the root bridge. To reset the default spanning-tree priority use the no form of this

command.

Syntax

spanning-tree priority priority

no spanning-tree priority

ƒ

priority — Priority of the bridge. (Range: 0 - 61440 in steps of 4096)

Default Configuration

The default bridge priority for IEEE STP is 32768.

Command Modes

Global Configuration mode

User Guidelines

The lower the priority, the more likely the bridge is to be the Root Bridge.

Example

The following example configures spanning-tree priority to 12288.

Console(config)# spanning-tree priority 12288

5.21.7 spanning-tree disable

The spanning-tree disable interface configuration command disables spanning-tree on a specific port. To enable spanning-tree

on a port use, the no form of this command.

Syntax

spanning-tree disable

no spanning-tree disable

Advertising