Planet Technology WGSD-8000 - Manual (Page 202)

User’s Manual of WGSD-1022/WGSD-8000
- 202 –
User Guidelines
Commands under the interface range context are executed independently on each active interface in the range. If the command
returns an error on one of the active interfaces, it does not stop executing commands on other active interfaces.
Example
The following example shows how ports e1 to e4 and ports g1 to g2 are grouped to receive the same command.
Console(config)# interface range ethernet e1 – e4, g1 - g2
Console(config-if)#
5.7.3 shutdown
The shutdown interface configuration command disables interfaces. To restart a disabled interface, use the no form of this
command.
Syntax
shutdown
no shutdown
Default Configuration
The interface is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel, out-of-band Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example disables Ethernet e5.
Console(config)# interface ethernet e5
Console(config-if)# shutdown
The following example re-enables Ethernet port e5.
Console(config)# interface ethernet e5
Console(config-if)# no shutdown