Planet Technology WGSD-8000 - Manual (Page 210)

User’s Manual of WGSD-1022/WGSD-8000
- 210 –
Flow Admin Back Mdix
Port Type Duplex Speed Neg control State Pressure Mode
-------- ------------ ------ ----- -------- ------- ----- -------- ----
e1 100M-Copper Full 100 Enabled Off Up Disabled Auto
e2 100M-Copper Full 100 Enabled Off Up Disabled Auto
e3 100M-Copper Full 100 Enabled Off Up Disabled Auto
e4 100M-Copper Full 100 Enabled Off Up Disabled Auto
e5 100M-Copper Full 100 Enabled Off Up Disabled Auto
e6 100M-Copper Full 100 Enabled Off Up Disabled Auto
e7 100M-Copper Full 100 Enabled Off Up Disabled Auto
e8 100M-Copper Full 100 Enabled Off Up Disabled Auto
g1 1G-Combo-C Full 1000 Enabled Off Up Disabled Auto
g2 1G-Combo-C Full 1000 Enabled Off Up Disabled Auto
Flow Admin
Ch Type Speed Neg control State
-------- ------- ----- -------- ------- -----
ch1 -- -- Enabled Off Up
ch2 -- -- Enabled Off Up
ch3 -- -- Enabled Off Up
ch4 -- -- Enabled Off Up
ch5 -- -- Enabled Off Up
ch6 -- -- Enabled Off Up
ch7 -- -- Enabled Off Up
ch8 -- -- Enabled Off Up
The displayed port configuration information includes the following:
ƒ Port—The port number.
ƒ Port Type—The port designated IEEE shorthand identifier. For example 1000Base-T refers to 1000 Mbps baseband
signaling inluding both Tx and Rx transmissions.
ƒ Duplex—Displays the port Duplex status.
ƒ Speed—Refers to the port speed.
ƒ Neg—Describes the Auto-negotiation status.
ƒ Flow Control—Displays the Flow Control status.
ƒ Back Pressure—Displays the Back Pressure status.
ƒ MDIX Mode—Displays the Auto-crossover status.
ƒ Admin State—Displays whether the port is enabled or disabled.
5.7.15 show interfaces status
The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | out-of-band-eth oob-interface]
ƒ Interface — A valid Ethernet port.