Planet Technology WGSD-8000 - Manual (Page 22)

User’s Manual of WGSD-1022/WGSD-8000
- 22 –
Step6 : Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling and supply
power to the switch.
2.2.3 Installing the SFP transceiver
The sections describe how to insert an SFP transceiver into an SFP slot.
The SFP transceivers are hot-pluggable and hot-swappable. You can plug-in and out the transceiver to/from any SFP port
without having to power down the Switch. As the Figure 2-7 appears.
Figure 2-7 Plug-in the SFP transceiver
Approved PLANET SFP Transceivers
PLANET WGSD-Switch support both single mode and multi mode SFP transceiver. The following list of approved PLANET SFP
transceivers is correct at the time of publication:
■ MGB-SX SFP (1000BASE-SX SFP transceiver )
■ MGB-LX SFP (1000BASE-LX SFP transceiver )
#
Note :
It recommends using PLANET SFPs on the Switch. If you insert a SFP transceiver that is not
supported, the Switch will not recognize it.
Before connect the other switches, workstation or Media Converter.
1. Make sure both side of the SFP transfer are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transfer model.
¾ To connect to 1000Base-SX SFP transfer, use the multi-mode fiber cable- with one side must be male duplex LC
connector type.
¾ To connect to 1000Base-LX SFP transfer, use the single-mode fiber cable-with one side must be male duplex LC
connector type.
Connect the fiber cable