Planet Technology WGSD-8000 - Manual (Page 204)

User’s Manual of WGSD-1022/WGSD-8000
- 204 –
User Guidelines
The command "no speed" in port-channel context returns each port in the port-channel to its maximum capability.
Before attempting to force a particular duplex mode the port operating at 10/100 Mbps, disable the auto-negotiation on that port.
Example
The following example configures the speed operation of Ethernet e5 to force 100-Mbps operation.
Console(config)# interface ethernet e5
Console(config-if)# speed 100
5.7.6 duplex
The duplex interface configuration command configures the full/half duplex operation of a given Ethernet interface when not
using auto-negotiation. To restore the default, use the no form of this command.
Syntax
duplex {half | full}
no duplex
ƒ half—Force half-duplex operation
ƒ full—Force full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet, out-of-band Ethernet) mode
User Guidelines
Before attempting to force a particular duplex mode on the port operating at 10/100 Mbps, disable the auto-negotiation on that
port.
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet e5 to force full duplex operation.
Console(config)# interface ethernet e5
Console(config-if)# duplex full