Planet Technology WGSD-8000 - Manual (Page 352)

User’s Manual of WGSD-1022/WGSD-8000
- 352 –
Console (config)# interface ethernet e8
Console (config-if)# switchport general pvid 234
5.27.13 switchport general ingress-filtering disable
The switchport general ingress-filtering disable interface configuration command disables port ingress filtering.
To enable ingress filtering on a port, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to enables port ingress filtering on e8.
Console (config)# interface ethernet e8
Console (config-if)# switchport general ingress-filtering disable
5.27.14 switchport general acceptable-frame-type taggedonly
The switchport general acceptable-frame-type tagged-only interface configuration command discards untagged frames at
ingress. To enable untagged frames at ingress, use the no form of this command.
Syntax
switchport general acceptable-frame-type tagged-only
no switchport general acceptable-frame-type tagged-only