Paradyne 9128-II - Manual (Page 150)

4. Security and Logins
4-8 April 2002 9128-A2-GB20-60
Limiting Telnet or FTP Access Over the TS Access Management Link
Procedure
To limit Telnet or FTP access when the session is on the TS Access Management
Link:
1. Select the Telnet and FTP Session options.
Main Menu
→
Configuration
→
Management and Communication
→
Telnet and FTP Sessions
2. Disable Telnet Session and/or FTP Session, as appropriate.
3. Return to the Management and Communication menu, and select Node IP.
4. Set the following configuration options, as appropriate.
5. Save your changes.
See Configuring Telnet and/or FTP Session Support or Configuring Node IP
Information in Chapter 3, Configuration, for more information about these
configuration options.
To . . . Set the configuration option . . .
Disable access via the TS
Access Management Link TS Access Management Link to None.
Assign an access level to the
TS Access Management Link TS Access Management Link’s Access Level to
Level-2 or Level-3.
NOTE: Regardless of a user’s login access level, a
user cannot operate at a level higher than the
access level specified for the session (e.g., if a user
has a Level-1 login and Level-2 telnet access has
been set, the Level-1 user can only operate as a
Level-2 user).
If you are going to allow users to configure the unit,
keep the access at Level-1.