Paradyne 9128-II - Manual (Page 331)

B. SNMP MIBs and Traps, and RMON Alarm Defaults
9128-A2-GB20-60 April 2002 B-9
Trap: warmStart
This trap indicates that the FrameSaver unit has been reset and has stabilized.
Trap: authenticationFailure
This trap indicates that access to the FrameSaver unit was unsuccessful due to
lack of authentication.
Table B-3. warmStart Trap
Trap What It Indicates Possible Cause
warmStart FrameSaver unit has just
reinitialized and stabilized itself. T Reset command sent.
T Power disruption.
String:
‘Unit reset.’
Variable-Binding
devLastTrapString
(devHealthAndStatus. mib)
Table B-4. authenticationFailure Trap
Trap What It Indicates Possible Cause
authenticationFailure Access to the FrameSaver
unit was attempted and
failed. T Bad password on COM port
terminal.
String:
‘Unauthorized access
attempted from COM port.’
T Bad password on modem port
terminal.
String:
‘Unauthorized access
attempted from modem port.’
T Bad password through telnet.
String:
‘Unauthorized access
attempted from telnet user at
$ipAddress.’
T SNMP bad community,
unauthorized IP address, or
unauthorized operation.
String:
‘Unauthorized access
attempted from SNMP user at
$ipAddress.’
authenticationFailure Variable-Binding T An ISDN backup call has been
received, but the call was
rejected.
String:
‘Bad Caller ID $phone.’
($phone is either a phone
number or “no number.”)
devLastTrapString
(devHealthAndStatus.mib)