Paradyne 9128-II - Manual (Page 275)

6. Troubleshooting
9128-A2-GB20-60 April 2002 6-39
IP Ping Test – Procedure 1
Procedure
To ping any far-end FrameSaver unit:
1. Select the IP Ping test.
Main Menu
→
Test
→
IP Ping
2. Enter the IP Address of the device the ping is being sent to, then select Start.
NOTE:
If the FrameSaver unit has just initialized, or the far-end unit has just
initialized, it may take about a minute for the units to learn the routes via
the proprietary RIP.
3. Verify the results of the IP Ping test.
— While the test is running, In Progress... appears in the Status field.
— When the test is finished, Alive should appear as the Status. If any
other message is displayed, additional testing is required.