Paradyne 9128-II - Manual (Page 335)

B. SNMP MIBs and Traps, and RMON Alarm Defaults
9128-A2-GB20-60 April 2002 B-13
Traps: enterprise-Specific
These traps indicate that an enterprise-specific event has occurred. Supported
enterprise-specific traps are listed below.
Table B-7. enterprise-Specific Traps and Variable-Bindings (1 of 3)
Trap Variable-Bindings Possible Cause
enterpriseCIR-
Change(15) T devFrExtDlciIfIndex
(devFrExt.mib)
T devFrExtDlciDlci
(devFrExt.mib)
T devFrExtDlciCIR
(devFrExt.mib)
T devLastTrapString
(devHealthAndStatus.-
mib)
CIR has changed due to the LMI
report. LMI Protocol is set to
Standard and the network’s CIR
changed.
String:
‘CIR on $ifString changed to
$CIR bps.’
enterpriseConfig-
Change(6) T devLastTrapString
(devHealthAndStatus.-
mib) Configuration has been changed
via the menu-driven user
interface, an SNMP Manager, or
auto-configuration after
60 seconds has elapsed without
another change.
String:
‘Device configuration change.’
enterpriseDLCI-
delete (17) T devFrExtDlciIfIndex
(devFrExt.mib)
T devFrExtDlciDlci
(devFrExt.mib)
T devLastTrapString
(devHealthAndStatus.-
mib.)
The DLCI has been deleted. The
network no longer supports the
DLCI, and it was removed.
Strings:
‘$ifString deleted by Auto-DLCI
delete.’’
enterpriseDLCI-
Down(11) DLCI Status is set to Inactive; the
DLCI is down.
Strings:
‘$ifString down.’ (Due to LMI or
physical failure.)
‘$ifString administratively
shutdown.’ (Due to an intentional
shutdown.)
enterpriseDLCIUp(12) DLCI Status is set to Active; DLCI
is up again.
String:
‘$ifString up.’