Oki 5300 Plus - Manual (Page 69)

56 Customizing
0 2 MCF(MULTI-LOC.): This function automatically prints
a Message Confirmation Report after each multiple-
location transmission. The report provides informa-
tion about the transmission—see page 60 for details.
Available settings are ON(default) and OFF.
0 3 ERR REPORT(MCF): This function automatically prints
a Message Confirmation Report each time an error
occurs during a transmission or polling transmission
operation. The report provides information about
the transmission—see page 64 for details. Available
settings are ON (default) and OFF.
04 IMAGE IN MCF: When a message confirmation of a
memory transmission is printed, this function adds a
portion of the first page of the document that was
sent. This feature makes it easier to identify a fax,
but it may present security problems if you are
sending sensitive documents. Available settings are
ON (default) and OFF.
0 5 SENDER ID: This function controls the printing of
your OKIFAX’s Sender ID on the faxes you send.
See page 23 for details. When turned on, the Sender
ID will be printed on each page slightly outside the
image area of your document. The default setting is
ON.
Note: In order to meet FCC requirements, you must have
this feature set to ON and have a valid Sender ID
programmed in your OKIFAX.
0 6 MONITOR VOLUME: This function sets the volume
for telephone line monitoring during dialing. Avail-
able settings are LOW (default), HIGH, and OFF.
0 7 BUZZER VOLUME: This function sets the volume of
the various tones your OKIFAX emits during opera-
tion. Available settings are LOW, MIDDLE (default),
and HIGH.
08 CLOSED NETWORK: This function allows you to pro-
gram your OKIFAX to refuse to communicate with
locations whose telephone numbers have not been
programmed into your One Touch keys or Auto Dial
locations. Using this function, you can set up a
closed network of fax machines—see page 40 for
details. If you do not want your OKIFAX to transmit
faxes to or receive faxes from locations outside your
network, select T/R. If you only want your OKIFAX
to refuse to receive faxes from outside your net-
work, select RX. Available settings are OFF (default),
T/R, and RX.
0 9 TX MODE DEFAULT: Your OKIFAX is set for the STD
(standard) resolution setting and the NORMAL
contrast setting. If you consistently send faxes that
require some other combination of transmission
modes, use this function setting to change the
default modes. While you are programming, the
new default combinations appear on the lights
above the Yes § and the No © keys. The default is
STD/NORMAL.