Oki 5300 Plus - Manual (Page 73)

60 Customizing
that case, incoming faxes are saved directly to the
PC’s disk without being printed. If the PC is turned
off or not functioning, the OKIFAX acts as a stand-
alone fax machine and prints incoming faxes when
this PC/FAX SWITCH function is set to ON (default).
If this function is set to OFF, the OKIFAX will not
accept incoming faxes when the PC is turned off or
not functioning.
2 3 ONE TOUCH PARAM: This function allows you to acti-
vate the Echo Protection feature for a specific One
Touch key, without changing the normal settings.
Echo Protection can improve communication with a
location in a noisy telephone area. For instructions
on changing One Touch Parameters settings for a
One Touch key, see page 31.
Changing Your User Function Settings
1 Press the Select Function key.
2 Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
3 Press the Yes
ᮤ key. The display shows FUNCTION
NO. [ ].
4 Using the numeric keypad, enter the 2-digit number
of the function you want to change. The display
shows the name of the selected function.
5 Repeatedly press the No
ᮣ
key until the setting you
want appears in the display.
Note: If you are changing the TX MODE DEFAULT set-
tings, the new settings appear on the lights above the
Yes
ᮤ and the No ᮣ keys
6 Press the Yes ᮤ key to confirm your selection. The
name of the next function setting appears in the
display.
7 Press the Select Function key to finish.
Dial Parameter Settings
These functions allow you to control the way your
OKIFAX dials telephone numbers. Refer to the Dial
Parameter Settings List below to determine which
settings you may need to change, then refer to
Changing Your Dial Parameter Settings (page 60) to make
the change.
Dial Parameter Settings List
REDIAL TRIES: This function controls how many times
your OKIFAX automatically redials a number that is
busy or does not answer. Available settings are from
0 to 10 tries. Default: 3 tries.
REDIAL INTERVAL: This function controls how long your
OKIFAX waits between each automatic redial at-
tempt. Available settings are from 1 to 6 minutes.
Default: 3 minutes.