Oki 5300 Plus - Manual (Page 70)

Customizing 57
10 T/F TIMER PROG.: When set to the telephone/fax
answering mode, your OKIFAX automatically
distinguishes between incoming voice and fax calls.
If the incoming call is a voice call, OKIFAX rings to
tell you to pick up the handset. If you do not
answer, OKIFAX automatically switches back to
facsimile mode to allow the calling party to send a
fax. The T/F TIMER function controls how long it
waits before switching back to fax mode. Available
settings are 20 SECONDS or 35 SECONDS (default).
1 1 RING RESPONSE: This function controls how long
your OKIFAX waits before answering an incom-
ing telephone call. The available settings are 1
RING (default), 5 SECONDS, 10 SECONDS, 15
SECONDS, or 20 SECONDS.
Note: At the default 1-ring setting, your OKIFAX answers
calls immediately, and you will not hear any ring. If you
need to hear the ring, change to one of the other
settings.
12 DISTINCTIVE RING: Distinctive ringing is a service of-
fered by some telephone carriers. It lets you have
different numbers on one line, each with its own
distinctive ring. You can then use one number exclu-
sively as a fax number without the expense of a sec-
ond line. (Your local telephone carrier can provide
you with more information about this service, which
usually has an additional charge.) To use this func-
tion, refer to Setting Your Fax Machine’s Ring Pat-
tern below. Available settings are OFF (default) and
ON.
Notes: Notes: Notes: Notes: Notes:
■ You must have your local telephone carrier’s
Distinctive Ring service.
■ Your OKIFAX must be in FAX or PC answer mode,
and the PBX dial parameter must be set to OFF. Other
modes–TEL, TEL/FAX, or TAD–will override Distinctive
Ring.
■ This feature may not work properly if you have a
telephone other than a genuine Oki optional handset
connected to your OKIFAX.
Setting Distinctive Ring
To set up your OKIFAX to recognize another ring
pattern:
1 Press the Select Function key.
2 Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
3 Press the Yes
ᮤ key. The display shows
FUNCTION NO. [ ].
4 Using the numeric keypad, enter 12. The
display shows DISTINCTIVE RING, OFF.
5 Press the No
ᮣ
key two times. The display
changes to
DISTINCTIVE RING, SET.