Zebra Technologies P1013372-001 REV. A - Manual (Page 153)

Setting Custom Card Specifications
Adjustments
P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 149
Back of card
Partial transfer is usually caused by lack of energy being transferred to the card, i.e. the
temperatures are too low or the speeds are too fast.
Step 1. Increase Back Transfer Temperature:
a. From the Card Specifications window, make a note of the default back transfer
temperature settings; see
Section B.3 .
b. Increase the appropriate (single or double side) back transfer temperature by 5.
c. Click on the OK button.
d. Print a test card; see Section B.3 .
e. Examine the test card.
• If there is noticeable improvement, continue increasing the back transfer
temperature by 5, printing a test card, and examining the resulting card. Stop
when the problem is corrected or there is no more improvement. If the
problem is corrected, no more adjustment is required; otherwise go to
Step 2 .
• If there is no noticeable improvement, return the temperature to its default
setting; and go to Step 2 .