Zebra Technologies P1013372-001 REV. A - Manual (Page 82)

78 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
Printer Settings and Adjustments
Card Printer Printing Preferences
Inhibit Pop-Up
The Inhibit pop-up window allows you to select the inhibit panel area for mag stripe, signature
panel, or other non-printing areas of a card. This window is available only when using ribbons
with an inhibitor panel; e.g., YMCKi.
To access the Inhibit pop-up window, select Start > Printers and Faxes. Right click on the
Zebra ZXP Series 8 Card Printer listing, and select Printing Preferences > Card Setup.
Select Ribbon info > Front Inhibit... or Back Inhibit...
The figure below shows settings for the front side of the card; settings for the back side of the
card are identical.
• Select the inhibit panel area:
- Disable Inhibit: Default.
- Inhibit printing on magnetic stripe: Places a no-print zone arounnd the mag
stripe area.
- Inhibit printing on smartcard contact: Places a no-print zone arounnd the
smartcard chip area.
- Custom file based inhibit area: See below.
• Bitmap based inhibit panel area: This option is enabled when Custom file based inhibit
area (see above) is selected. To locate the bitmap, click on the Browse button to bring up
a dialog for choosing the file.