Installing the cleaning roller – Zebra Technologies P1013372-001 REV. A User Manual
Page 18
14
Zebra ZXP Series 8 Card Printer with Laminator
P1013372-001 Rev. A
Installation and Setup
Installing the Cleaning Roller
Installing the Cleaning Roller
The Cleaning Roller cleans the cards entering the Printer from either the Input Hopper or the
Single-Feed Input.
Step 1.
Remove the Cleaning Roller from its packaging. To avoid contamination, always
hold the roller by the ends.
Step 2.
Peel the protective wrapper from the Cleaning Roller.
Step 3.
Open the Printer Door by pressing the Door Release button on the top of the Printer.
Step 4.
Locate the area where the Cleaning Roller will be installed; circled below.
Step 5.
Hold the Cleaning Roller by the ends.
Step 6.
Position the ends of the Cleaning Roller in the slots.
Step 7.
Push down until the roller fully seats and latches.
Step 8.
Close the Printer’s Door.