Zebra Technologies P1013372-001 REV. A User Manual
Page 22
Advertising
18
Zebra ZXP Series 8 Card Printer with Laminator
P1013372-001 Rev. A
Installation and Setup
Loading a Print Ribbon
Step 2.
Load the print ribbon supply spool onto the supply spindles, purple flange side to
the left.
Step 3.
Load the empty take-up spool onto the take-up spindle, blue flange side to the right.
Step 4.
Make sure the spring-loaded spindles on the left seat into the spools.
Step 5.
Make sure the print ribbon comes off the bottom of the supply spool and feeds to the
bottom of the take-up spool.
Step 6.
The figure below shows the proper installation of the print ribbon.
Advertising