Zebra Technologies P1013372-001 REV. A User Manual
Page 27
Advertising
Installation and Setup
Loading the Laminate
P1013372-001 Rev. A
Zebra ZXP Series 8 Card Printer with Laminator
23
Step 3.
Carefully following the guidelines in the following figure, place the laminate in
the cassette.
•
Upper Laminate Cassette (present on both the single-sided laminator and dual-
sided laminator):
•
Lower Laminate Cassette (only present on the dual-sided laminator):
Step 4.
Pull out an inch or two of laminate past the lip of the cassette.
Step 5.
Close the cassette by firmly pressing the “clamshell” together. You will hear a click
and feel a detent when the halves of the cassette seat together.
Step 6.
If the exposed end of the laminate is uneven or crinkled, cut it as square as you can
with scissors.
Advertising