Zebra Technologies P1013372-001 REV. A - Manual (Page 170)

166 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
Setting Custom Card Specifications
Adjustments
B.4.5 Flash
Flash is usually caused by too much energy being transferred to the card (i.e., temperatures are
too high or input speed is too slow) and not allowing enough time for the cards to cool while
exiting the transfer station (i.e., exit speed is too fast).
Side Edge
Step 1. Decrease Front Transfer Temperature:
a. Go to the Card Specifications window; see Section B.3 .
b. Make a note of the default front transfer temperature settings.
c. Decrease the appropriate (single or double side) front transfer temperature by 5.
d. Click on the OK button.
e. Print a test card; see Section B.3 .
f. Examine the test card.
• If there is noticeable improvement, continue decreasing the front transfer
temperature by 5, printing a test card, and examining the resulting card. Stop
when the problem is corrected or there is no more improvement. If the
problem is corrected, no more adjustment is required; otherwise go to
Step 2 .
• If there is no noticeable improvement, return the temperature to its default
setting; and go to Step 2 .