VEGA VEGASON 51V…53V - Manual (Page 72)

72 VEGASON 51 V … 53 V
6.4 Adjustment with PC on
VEGALOG
For connection of the PC to the processing
system VEGALOG you require a standard
interface RS232 DTE-DTE (Data Terminal
Equipment) interface cable.
With this cable you connect the PC with the
processing system.
Set-up - Adjustment with PC on VEGALOG
The first set-up steps with the PC in conjunc-
tion with the processing system VEGALOG
correspond to the adjustment in chapter "
6.2
Adjustment with VEGAMET or MINICOM".
• Connect the standard output of your PC
with the standard RS232-interlink cable (9-
pole) with the processing system
VEGALOG.
• Now switch on the power supply of the
processing system.
After approx. 1…2 minutes (selfcheck) the
meas. system consisting out of processing
system and sensors is normally ready for
operation and the sensors indicate measured
values.
• Now start the adjustment software VVO on
your PC.
• Choose in the initial screen with the arrow
keys or the mouse the point " Planning" and
click to "OK".
In the next window you are asked for the
identification.
DTE DTE
DCD 1 1 DCD
RxD 2 2 RxD
TxD 3 3 TxD
DTR 4 4 DTR
GND 5 5 GND
--- 6 6 ---
--- 7 7 ---
--- 8 8 ---
--- 9 9 ---
Via the signal and supply lines between sen-
sor and processing system also adjustment
signals are transmitted digitally beside the
measured values. The adjustment program
VVO can then communicate with the
processing system and all connected sen-
sors. In chapter "2.2 Configuration of measur-
ing systems" the connection of the PC to the
various meas. systems is shown.
Before starting with the set-up:
The many pictures, adjustment steps and
menus may be confusing but just carry out
the set-up with the PC step-by-step and you
will soon no more require the following pages.
When you want to enter or enquire something
this is marked in the following with a dot, e.g.
• Choose …
• Start …
• Click to …