Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 155)

6. After verifying that the IP address change was successful, enter and issue the arp –d
command at the Command prompt. For example:
arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table
or
arp –d* removes all static IP addresses from the ARP table.
Connecting as a Telnet Client
The Telnet utility is available via the Command prompt. Telnet allows you to input SIS
commands to the MTPX Plus matrix switcher from the PC via the Ethernet link and the LAN.
Access the Command prompt and start Telnet as follows:
1. On the Windows task bar, click Start > Run .
2. At the Open prompt, type command .
1. Click the OK button.
2. At the Command prompt, type Telnet and then press <Enter>. The computer returns a
display similar to the one shown in figure 84.
Microsoft (R) windows 2000 (TM) Version 5.0 (Build 2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99203.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
Figure 84. Telnet Window
MTPX Plus 6400 Series Matrix Switchers • Ethernet Connection 149