Extron Electronics MTPX Plus 6400 Series User Guide User Manual
Page 9
The matrix switcher can be remotely controlled via its rear panel Remote (RS-232/RS-422)
port and its front panel Configuration (USB) port using either the Extron Matrix Switchers
Control Program or the Simple Instruction Set (SIS™). The SIS is a set of basic ASCII code
commands that provides control through a control system or PC.
The switcher can be operated remotely by any of the following when that device is
connected to either MTPX Plus port:
z
z
A control system
z
z
A PC
z
z
An Extron MKP 2000 remote control panel
z
z
An Extron MKP 3000 remote control panel
Outputs 1 through 16 support bidirectional pass-through RS-232 signals from a dedicated
source (rather than from the selected input), which can be directly inserted into the signal
set routed to the TP output. You can even route RS-232 on a link that is normally for audio,
such as to an MTP U R 15HD RSA SEQ receiver, which can autodetect whether its signal
input includes an audio component or an RS-232 component.
The switchers can also switch RGBS, RGsB, RsGsBs, HDTV, component video, S-video, and
composite video.
MTPX Plus 6400 Series Matrix Switchers • Introduction
3