Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 96)

Starting the program
1. To run the Matrix Switchers Control Program, click Start > Programs > Extron
Electronics > Matrix Switchers > MATRIX Switcher + Control Pgm .
The Comm Port Selection window (see figure 32) appears.
Figure 32. Comm Port Selection Window
2. Choose among the comm port that is connected to the serial port of the switcher, USB ,
IP [LAN] , or Emulate .
z z If you selected a comm port, check the baud rate displayed in the Baud Rate
field. If you need to change the baud rate, click the
Baud button
and double-click on the desired baud rate.
Click
OK . The Extron Matrix Switchers Control Program window
(see figure 34 and figure 35 ) appears, displaying the current
configuration of the attached matrix. Proceed to “ Using the
program .”
If you selected USB , select the MTPX Plus matrix switcher in the
drop-down window and click OK . Proceed to “ Using the program .”
z z If you selected IP [LAN] , click OK and proceed to step 3.
If you selected Emulate , click OK and see “ Using Emulation Mode “ on
page 110.
3. If you selected IP [LAN] in step 2, the IP Connection window appears (see figure 33).
Figure 33. Address and Password Entry
a. Examine the Matrix IP Address field in the IP Connection window.
The field displays the last Extron IP address entered.
If the IP address is correct, proceed to step 3b.
If the address is not correct, either click in the
Extron IP Address field and
enter the IP address or click on the scroll down button ( ) and select from among
the recently used addresses. Proceed to step 3b.
MTPX Plus 6400 Series Matrix Switchers • Matrix Software 90