Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 65)

Performing Soft System Resets (Modes 3, 4, and 5)
Perform a soft reset of the switcher as follows:
1. Use an Extron Tweeker or other small screwdriver to press and hold the rear panel
Reset button until the rear panel Reset LED and the front panel Preset and View
buttons blink once (events reset), twice (IP settings reset), or three times (absolute reset)
(see figure 25).
2. Release the Reset button and then immediately press and release the Reset button
again. Nothing happens if the second momentary press does not occur within 1 second.
I / O
VIDEO AUDIO
I / O
VIDEO AUDIO
I / O
VIDEO AUDIO
RESET RESET RESET
RESET RESET RESET
RESET RESET RESET
Release, then immediately
press and release again.
IP Settings
Reset
Absolute Reset
Press and hold
the Reset button.
Events Reset
(Mode 4)
(Mode 5)
(Mode 3)
Front panel I/O buttons flash once.
Reset LED flashes several times at 3 seconds.
Release, then immediately
press and release again.
Reset LED flashes several times at 3 seconds,
and again at 6 seconds.
Press and hold
the Reset button.
Reset LED flashes several times at 3 seconds,
at 6 seconds, and again at 9 seconds.
Press and hold
the Reset button.
Front panel I/O buttons flash twice.
Front panel I/O buttons flash three times.
Release, then immediately
press and release again.
Figure 25. Soft System Resets
MTPX Plus 6400 Series Matrix Switchers • Operation 59