Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 162)

Audio output — local
Number/signal type ........................ 8 dual mono, balanced/unbalanced
Connectors .................................... (8) 3.5 mm captive screw connectors, 5 pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced ±10%
Gain error ...................................... ±1 dB channel to channel
Maximum level (=10k ohms) .......... >+16 dBu, balanced or unbalanced at 1% THD+N
Maximum level (600 ohm) .............. >+20 dBm, balanced or unbalanced at 1% THD+N
Audio output — main (see receivers' input specifications)
Number/signal type ........................ 32, 48, or 64 proprietary analog signals
Connectors .................................... 32, 48, or 64 female RJ-45 connectors
Control/remote — switcher host control
Serial host control port ................... 1 bidirectional RS-232 or RS-422, rear panel 9-pin female D connector
Baud rate and protocol ................... 9600 (default), 19200, 38400, 115200 baud, adjustable; 8 data bits, 1 stop bit,
no parity
Serial control pin configurations
9-pin female D connector
RS-232 ............................... 2 = Tx, 3 = Rx, 5 = GND
RS-422 ............................... 2 = Tx-, 3 = Rx-, 5 = GND, 7 = Rx+, 8 = Tx+
USB control ports ........................... 1 front panel female mini USB B
USB standards ................................ USB 2.0, USB 1.1, USB 1.0 compatible
USB data rates ................................ Low speed (1.5 Mbps), full speed (12 Mbps), high speed (480 Mbps)
Ethernet control port ...................... 1 RJ-45 female
Ethernet data rate (for network communication)
10/100Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ARP, ICMP (ping), IP, TCP, DHCP, HTTP, SMTP, Telnet
Ethernet default settings ................ Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
Web server ..................................... Up to 200 simultaneous sessions
3.0 MB nonvolatile user memory
Program control ............................. Extron control/configuration program for Windows ®
Extron Simple Instruction Set (SIS ™ )
Microsoft ® Internet Explorer ® ver. 6 or higher, Telnet
Control/remote — external device (pass-through, unidirectional, or bidirectional)
Serial control ports ......................... 16 RS-232, 3.5 mm captive screw connectors, 3 pole
Baud rate and protocol ................... Up to 38400 baud, 9600 baud (default); 5-8 data bits; 1 or 2 stop bits; odd, even,
or no parity; XON, XOFF, or no flow control
NOTE: Protocol is mirrored between the switcher and the receiver.
Serial control pin configurations ..... 1 = Tx, 2 = Rx, 3 = GND
Control/remote — RS-232 insertion from Ethernet port
Serial control ports ......................... UART, uni- or bi-directional, on female RJ-45 connectors shared with twisted pair
output
6464, 4864 models ................. 64 ports
6448, 4848 models ................. 48 ports
6432 model ............................. 32 ports
Baud rate and protocol ................... Up to 38400 baud, 9600 baud (default); 5-8 data bits; 1 or 2 stop bits; odd, even,
or no parity; XON, XOFF, or no flow control
MTPX Plus 6400 Series Matrix Switchers • Reference Information 156