Extron Electronics MTPX Plus 6400 Series User Guide - Manual (Page 91)

Command ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
IP setup commands (continued)
Set email recipient EX5! , X5@ CR } Ipr X5! , X5@ , ] This command sets the recipient. To
receive email notifications, you must
then set the events that the switcher
reports, using one or more separate
Set email events (EM) commands
(see below).
Example: E 72,[email protected] }
Ipr72,[email protected], ]
Read email recipient EX5! CR } X5@ , ]
Set email events for recipient EX5#X5! , X5$ , X5% EM } Ipe X5# , X5! , X5$ , X5%] You must first have set an e-mail
recipient for the email account
number (
X5! ), using the separate Set
email recipient (CR) command.
Example: E I72,0,3EM } IpeI*72*0*3 ] Email account 72 (recipient 8),
JSmith, will receive fail/missing
and fixed/restored messages for all
inputs.
Read e-mail events for a recipient EX5#X5! , X5$ EM } X5% , X5% , X5% , ... , X5%]
Set DHCP on or off EX5^ DH } Idh X5^] X5^ : 0 = off, 1 = on
Read DHCP on/off status E DH } X5^]
Set serial port parameters EX5& * X5* , X5( , X6) , X6! CP } Cpn X5& •Ccp X5* , X5( , X6) , X6!]
Read serial port parameters EX5& CP } X5* , X5( , X6) , X6!]
Set serial port mode EX5& * X6@ CY } Cpn X5& •Cty X6@] X6@ : 0 = RS-232, 1 = RS-422,
Read serial port mode EX5& CY } X6@]
Set verbose mode EX6# CV } Vrb X6#]
Read verbose mode E CV } X6#]
Configure current port timeout E 0* X6$ TC } Pti0* X6$]
View current port timeout E 0TC } X6$]
Configure global IP port timeout E 1* X6$ TC } Pti1* X6$]
View global IP port timeout E 1TC } X6$]
Special Characters
The HTML language reserves certain characters for specific functions. The switcher
does not accept these characters as part of preset names, the name of the switcher,
passwords, or locally created file names.
The switcher rejects the following characters or they are not recommended:
{space (spaces are ok for names)} + ~ , @ = ‘ [ ] { } < > ’ “ semicolon (;)
colon (:) | \ and ?.
Command/Response Table for IP-Specific SIS Commands (continued)
MTPX Plus 6400 Series Matrix Switchers • Programming Guide 85